Sliding glass doors
Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateTherma-Tru Sliding & Patio Doors: The Paradise Owner’s Guide
We install and service Therma-Tru-compatible sliding and patio door systems for Paradise homeowners, and most full door replacements land between $1,800 and $5,400 installed, depending on size, glass package, and whether the frame stays. We’re an independent service provider, not affiliated with Therma-Tru, and we’re straight about how the parts chain works: the failed roller, lock, or weather seal gets matched to your door’s series and vintage, then replaced on a scheduled visit. Fine, here’s a really common picture I’ve seen. The door stopped gliding sometime last year, then the latch started catching. Now you’re lifting the panel with your hip just to close it before you go to bed, and that small noise at night is the door you didn’t fix landing on your to-do list. We see that same story often in Paradise, and it almost always comes down to a handful of wear parts.
Which Therma-Tru Models This Applies To
Therma-Tru builds sliding and patio doors across several product families, and the wear parts are not one-size-fits-all across them. Roller assemblies, tandem roller carriages, mortise and multi-point lock hardware, and the weather seal on a slider all shift by series and by production year. That’s the first gotcha most folks don’t expect: two doors that look identical from the driveway can take different parts if they were built a few years apart. We match parts to the actual panel, not to a guess.
Here’s how we identify the right part. We start with the label on the door edge or the glass spacer, then take panel measurements and check the roller track height. If the label is gone, the measurements get us there. On the OEM-versus-aftermarket question, Therma-Tru factory parts are the safest match for newer doors under their original warranty, but quality aftermarket rollers and seals are often a better long-term value on doors past their factory coverage, and we’ll tell you which way makes sense for your door in Paradise. The same matching logic applies to the PGT, CGI, and CWS sliders we also handle.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Signs Your Therma-Tru Sliding & Patio Doors Is Failing
- The panel drags or needs a lift to slide. Flat-spotted or seized rollers are usually the cause, and a worn track or a frame that shifted out of square can make it worse. If the panel won’t stay put in the track, stop forcing it.
- The latch or multi-point lock won’t catch. This is often a worn keeper or a striker that no longer lines up after the panel settles. A door that won’t latch is one that can be pushed open from outside.
- Water or daylight at the sill after monsoon storms. Failed sweep seals and worn weather stripping let driven rain past the sill in Paradise, where summer storms push water sideways. By the time you see it inside, the bottom track may already be holding moisture.
- Condensation on the glass or a foggy panel. That points to a broken seal on the insulated glass unit, not the slider hardware. It’s a different repair, and worth pricing separately.
- The screen won’t glide or pops the track. Screen rollers and track alignment wear the same way door rollers do, and a bent screen frame will keep popping until it’s straightened or replaced.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work typically runs in Paradise. Roller and hardware swaps are the smallest ticket, and full door replacements sit at the top. Every number below is upfront, and we don’t move it once the work starts.
| What you’re pricing | Typical installed range |
|---|---|
| Roller, latch, or seal replacement | $160 – $420 |
| Full hardware kit (rollers, locks, weather seal) | $380 – $750 |
| Therma-Tru sliding/patio door replacement | $1,800 – $5,400 |
| Premium glass (impact-rated, low-E) upgrade | Adds $400 – $1,400 |
What drives the range: door size, glass package, series, and whether the existing frame and opening check out. You get a written line-item quote, so parts and labor are visible. The work is backed by our 36500-Day Done Right Promise, and if it’s not done right, we make it right. Standing offers apply as always: $40 off any repair over $200, free second opinions on written estimates, no trip charge inside the home county, and a permanent 10% discount for seniors and veterans.
DIY or Call Us?
Some things are safe to check yourself. Look for the door label, wipe and inspect the bottom track, and test the latch by hand. You can also check the sweep seal at the sill after a storm. What we’d steer you away from is pulling a panel out of its track and re-seating it, or forcing a binding panel to prove a point. A glass slider panel is heavy, the track is unforgiving, and a dropped panel on bare feet or a tile floor is a bad afternoon. Sliding doors are also an exterior door, meaning a missed seal is a security gap. That’s the honest line. If it’s binding, dragging, or won’t latch, call us at (833) 958-8388 for a free estimate.
FAQs
Factory rollers typically hold up five to ten years in regular use, and the door frame and glass can go twenty or more. In Paradise, the heat and the monsoon moisture stretch the low end, so a door facing the afternoon sun may need rollers sooner than the same door on a shaded side.
Often yes. A worn roller, keeper, latch, or seal can be swapped without replacing the door, which is why we match the part first. Call us at (833) 958-8388 and we’ll tell you honestly which way makes sense.
Roller, lock, or seal work is usually a half-day or less, and a full door replacement is a scheduled day or two. Call us at (833) 958-8388 to lock in a date, and we’ll confirm the timing with you before we set the appointment.
We identify your door’s series and vintage from the label or measurements, then order the matching factory or quality aftermarket part. We don’t carry parts on the truck, so the source is the right part for your door, not whatever’s lying around. Call us at (833) 958-8388 for a free estimate.
If your Therma-Tru slider is dragging, not latching, or leaking at the sill, we’ll match the right part to your door and get it back to gliding. Call (833) 958-8388 for a free estimate. We’re a neighbor you can call at 2 a.m., and someone will actually answer. Upfront pricing, no surprises on the invoice, and Ed’s name is on the door, and on every job we do. We’re the one down the road.
Written by the team at Winslow Windows & Doors Paradise, serving Paradise and nearby areas.