Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Sliding glass doors
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateTherma-Tru Door Installation in Paradise: What to Know First
We provide independent Therma-Tru door installation in Paradise, and a standard entry door swap is typically a one-day job once the door and hardware are on site. We quote every Therma-Tru job with upfront, line-item pricing before we touch the door, so you know what the install costs before the old slab comes out. As an independent Therma-Tru service provider, we’re not affiliated with or authorized by Therma-Tru, and we tell you that plainly because we’d rather earn the job than imply a badge we don’t have.
This page is for Paradise homeowners who already have a Therma-Tru door and need it installed correctly, replaced after years of sun and wind, or fixed when the swing, seal, or hardware stops behaving. Therma-Tru builds a genuinely good door, and the failures we see here usually trace to installation details, our desert climate, or hardware that aged faster than the slab did. Call us at (833) 958-8388 and a live person answers, day or night.
How Therma-Tru Products Fail – and How We Fix Them
Paradise sits in the Mojave, and doors here live a harder life than the same Therma-Tru unit would in a coastal town. Afternoon summer heat, low humidity, and the occasional wind-driven dust storm work over seals, finishes, and hardware year after year. Here are the Therma-Tru failure patterns we see most, and what we actually do about each one.
- Sagging and rubbing on Fiber-Classic and Smooth-Star slabs. A heavy Therma-Tru slab hung on a frame that was set slightly out of plumb will drag at the strike side within a couple of seasons, especially in west-facing entries that bake every afternoon. We check frame square and the hinge-side shim pack first, because re-hanging a good slab on a corrected frame usually beats replacing the door. Many “bad door” complaints in Paradise are really a bad install.
- Failed weatherstrip and bottom sweeps. Our heat and low humidity dry out the foam and vinyl seals Therma-Tru ships, and once the bottom sweep flattens you get daylight, dust, and a draft you can feel in December. We replace seals with OEM-equivalent profiles matched to the door’s kerf, which keeps the door’s rated seal and looks right from the curb.
- Entry-door finish breakdown on steel and fiberglass faces. Sun exposure here breaks down paint and stain film faster than most of the country, and a Therma-Tru fiberglass door that loses its topcoat will start taking on moisture at the edges and panel lines. We prep and re-finish to the door’s spec rather than slapping on a coat of hardware-store paint that traps moisture.
- Multipoint hardware that drifts out of adjustment on Fiber-Classic and Traditions entries. Handlesets and multipoint lock systems slowly lose alignment as the slab and frame settle, and homeowners end up slamming the door to get it to latch. We re-align the hardware and adjust the strike and keepers so the door latches with a light push, no shoulder needed.
- Frame rot and threshold wear at grade-level entries. A Therma-Tru frame that sits close to a Paradise patio slab will wick moisture at the sill and threshold long before the door slab itself shows trouble. We inspect the sill pan and threshold seal, and we replace or re-seal the assembly rather than installing a new slab over a compromised frame.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Our Therma-Tru Door Installation Process
Every Therma-Tru job runs the same way, from the first call to the last sweep of the broom. Here’s what a real install looks like with us.
- 1
Diagnose on site. We measure the opening, check the existing frame for plumb and square, and confirm the door model and hardware so the replacement is spec-matched, not guessed.
- 2
Parts decision. OEM Therma-Tru hardware when the door calls for it and the lead time works; a quality aftermarket equivalent when OEM isn’t practical. We tell you the trade-off on cost and fit before you decide, and we never cut corners on the sealing parts that keep water out.
- 3
Remove and prep. The old slab and any failed frame come out, and the rough opening gets squared, shimmed, and sealed. This is the step that separates a door that lasts from one that drags in two years.
- 4
Install and seal. The Therma-Tru door goes in plumb and level, hardware is fitted, and the frame is sealed and flashed so Paradise wind and rain stay outside where they belong.
- 5
Test. We open and close the door through a full swing, check the latch, seals, and threshold, and make sure it shuts with a light push and no daylight showing.
- 6
Clean up and back it up. We haul off the old door and debris, and the install is covered by our 36500-Day Done Right Promise. If it’s not done right, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Therma-Tru Door Installation Costs in Paradise
Therma-Tru door installation in Paradise generally falls into a few predictable ranges, and we quote each one upfront so you’re not guessing. Here’s roughly what to expect:
| Scenario | Typical Range |
|---|---|
| Replace a Therma-Tru slab in an existing sound frame | $450 – $900 |
| Full entry door replacement, frame and slab, hardware included | $1,200 – $3,200 |
| French or double-door install | $2,000 – $4,500 |
| Hardware re-alignment or seal and sweep replacement | $150 – $400 |
What moves the price: door model and material (fiberglass and steel differ), whether the frame needs replacing or just the slab, hardware grade, and any repair to the rough opening. We give you a written, line-item estimate free, and we don’t change the price once work starts. Call (833) 958-8388 to schedule yours.
Why Paradise Homeowners Call Winslow Windows & Doors Paradise for Therma-Tru Work
We’re locally owned and owner-operated, which means Ed Winslow’s name is on the door and on every job we do. That accountability is the whole reason to call us instead of a national chain that hands you a ticket number. When something’s off, you reach the same company that did the work, and our 36500-Day Done Right Promise backs it: if it’s not done right, we make it right.
Our technicians have up to 15 years of experience, they’re background-checked and arrive in uniform so you know who’s at your door, and we answer the phone live 24/7 – a neighbor you can call at 2 a.m. and someone actually picks up. We’re also an authorized installer for eight brands including PGT, CGI, CWS, ES Windows, ECO Window Systems, Mr-Glass, and ViewLux, so when a Therma-Tru job needs a different door or a matched component, we’re not stuck. Our standing offers are permanent, not a promo: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside our home county, and a 10% discount for seniors and veterans. Upfront pricing, no surprises on the invoice.
FAQs
Installation done to Therma-Tru’s written spec keeps the door’s warranty intact, and careless installation is what puts it at risk. We install the door and hardware the way the manufacturer’s instructions call for, so the slab and its finish are protected – and our own 36500-Day Done Right Promise covers our work on top of that.
Yes – we source OEM Therma-Tru hardware and sealing parts when the door calls for them, and use a quality aftermarket equivalent when OEM lead time or cost doesn’t make sense. We’ll tell you which we recommend and why before you decide. Call (833) 958-8388 for a free quote.
If the frame is sound and the slab is in good shape, a repair like a seal, sweep, or hardware re-alignment usually costs a fraction of a new door. We replace when the slab or frame has taken on real damage from sun and moisture – and we’ll show you what we see so the call is yours to make. Estimates are free.
A standard entry door replacement is typically a one-day job once the door and hardware are on site, and French or double-door installs can run longer depending on the opening. We’ll give you a realistic window with your written estimate, not a vague “sometime this week.”
Yes – we service and install Therma-Tru doors regardless of who did the original work. We diagnose the actual problem first, then quote the fix or replacement upfront. Call (833) 958-8388 to set up your free estimate.
Whether your Therma-Tru entry needs a fresh install, a replacement after years of Paradise heat, or a fix for a door that’s started to drag and draft, we’re the one down the road. Call Winslow Windows & Doors Paradise at (833) 958-8388 for your free estimate – a live person answers any hour, and upfront pricing means no surprises on the invoice.
Written by the team at Winslow Windows & Doors Paradise, serving Paradise and nearby areas.